AVIRE Memco Lift HAWK Einbauanleitung Seite 6

Full Programming Options
Modes On/Off
Mode Setup
Clock Setup
CAN Setup
Advanced
Modes
Remote Mode
Remote Access mode allows the user to trigger a Remote elevator test utilising either a DCP or. Memcom+.
Timed Mode
Timed Countdown mode is used to measure the dwell time of the elevator, if the dwell time of the elevator reaches the
specified time as set by the user, the elevator will then run an automated test.
Countdown Timer
24 Hours
12 Hours
8 Hours
4 Hours
2 Hours
1 Hour
30 Minutes
Test Mode - 60 seconds
Remote Mode
Timed Mode
Autonomous
Ext Sensor
Timer Setup
Sensitivity
Set Time
Shaft Number
Node Number
Hardware Number
Firmware Version
Device State
Door State
Re-Calibrate
Remote Access Mode On/Off
Countdown Timer Mode On/Off
Autonomous Self Learning Mode On/Off
External Sensor Monitor On/Off
Countdown Mode Timer Select
Auto/Self Learning Mode Sensitivity
Set the Clock
Set the shaft number 1-4 (DCP)
Set the node Number 0-3 (DCP)
Shows hardware number
Shows firmware Version
Accelerometer state
External Sensor State
Re-calibrate accelerometer
Test Option
The test mode is available to test the
functionality of the timed mode on
install, this setting can be used to test
the device setup, the interface with
the elevator buttons as well as the
emergency phone system. The test
will run after 60 seconds of inactivity
on the elevator.
6