AVIRE Memco Lift HAWK Einbauanleitung Seite 5

Quick Start
Menu Controls
Back
Scroll Up
Scroll Down
Forward / Accept
Digital Communication Platform
If the HAWK is connected to the Digital Communications Platform (DCP), A remote test is triggered via the AVIRE HUB
system, this allows the user to activate a remote test whilst also receiving live status updates from the lift.
Using the AVIRE HUB software, providing the device is connected to the Digital Communications Platform (DCP). users can
fully program the device from the HUB interface.
Users are also able to receive live status updates and previous movement time from the HUB interface.
Quick Start Menu Process
Step 1 Clock Setup
Step 2 Clock Adjust
Step 3 Setup
The device is shipped in plug and play mode, if no additional settings are
needed other than Remote access and Autonomous self-testing the device
works out of box after setting time and date.
Using the menu system
navigate to the clock menu.
1. From the home screen press
the ✔ Symbol.
2. Scroll down through the
menus to 'Clock Setup' and
press ✔
Adjust the current time/day to
the current.
1. Press the ✔ Symbol to
enter Set Time Menu
2. Use arrows and ✔ set the
correct time.
3. Press Back button to exit
and save
The device is configured
to use Remote Access and
Autonomous Self-Learning
mode on a Medium Setting. If
no further settings are required
then the device is ready to go.
Proceed to test the device via
a remote call.
5