Important Safety Instructions - Steibel Eltron Rtf-Trend Bedienungsanleitung

INTRODUCTION
The thermostat is an electronic PWM/PI thermostat for temperature
control by means of an NTC sensor located either externally or
internally within the thermostat.
The thermostat is for flush mounting in a wall box. A baseplate for
wall mounting is also available.
This thermostat can be used as a controller for electric room
heating pursuant to EN 50559.
CONTENTS
• Thermostat
• Sensor

IMPORTANT SAFETY INSTRUCTIONS

To avoid electric shock, disconnect the heating system
power supply at the main panel before carrying out any
work on this thermostat and associated components.
Protection against electric shock must be guaranteed
by appropriate mounting. The requirements of Class II are fulfilled
after appropriate mounting (reinforced insulation).
Installation must be carried out by qualified personnel in
accordance with appropriate statutory regulations (where required
by law).
Installation must comply with national and/or local electrical
regulations.
Caution
This instruction must be observed, otherwise the liability
of the manufacturer shall be voided.
Any changes or modifications made to this thermostat
shall void the liability of the manufacturer.
6
RTF-Trend
Instructions
English
(FIG. 1)
© 2022 OJ Electronics A/S © 2022 OJ Electronics A/S