Steibel Eltron RTF-Trend Bedienungsanleitung Seite 12

RTF-Trend
ERROR AND WARNING CODES
E0 ( ): Internal Compensation Sensor Error (Internal fault). The
C-5E
thermostat must be replaced.
E1 ( ): Internal Sensor Error (Built-in sensor defective or short-
I-5E
circuited). Replace the thermostat, or use the floor
sensor only.
E2 ( ): External Sensor Error (External sensor disconnected,
E-5E
defective or short-circuited). Reconnect the sensor if
disconnected, or replace the sensor.
E5 ( ): Internal OverHeat (Internal temperature limit exceeded).
I-OH
Inspect the installation.
MAINTENANCE
The thermostat is maintenance free.
Keep the air vents of the thermostat clean and unobstructed at all
times.
The thermostat must only be cleaned with a dry cloth.
APPROVALS AND STANDARDS
Regulations
OJ Electronics A/S hereby declares that the product is in
conformity with the following directives of the European
Parliament:
LVD - Low Voltage Directive
EMC - Electromagnetic Compatibility
RoHS - Restriction of the use of certain Hazardous Substances
WEEE - Waste Electrical and Electronic Equipment
ECO Design - Enviromentally friendly design
Applied standards and approvals
According to the following standard:
CE: EN 60730-1, EN 60730-2-9
UKCA: BS 60730-1, BS 60730-2-9
Classification
Protection from electric shock must be assured by appropriate
installation. Must be installed according to the requirements of
Class II (reinforced insulation).
12
© 2022 OJ Electronics A/S
English