Herunterladen Diese Seite drucken

Juice Technology BOOSTER 2 Bedienungsanleitung Seite 51

Mobile ladestation für elektrofahrzeuge

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

WARNING
Fire Hazard!
Defective or incorrectly dimensioned cables,
and/or defective or unauthorised fuse bridging
can result in fire or smouldering in the cable or
the outlet.
Notes:
• During the charging process, regularly check
the temperature of the power sockets and
cables. If they are hot, stop charging
immediately. "Hot" is when you cannot keep
your hand around the cable or connector for
more than 20 seconds.
• If the electrical installation is particularly old, it
may make sense to select a power level
below the one suggested.
• If several cars are charging up
simultaneously on the same fuse or if other
devices are connected, it is advisable to
adjust the boxes so that the total amperage
of all devices does not exceed the tripping
threshold of the load-breaker.
User Manual JUICE BOOSTER 2 [EL-JB2, EA-JB2] Version 2.00 EN
All manuals and user guides at all-guides.com
13.3. End the charging process
Always follow the sequence below:
• Interrupt or stop the charging process in the
car.
• JUICE BOOSTER 2 will stop the charging
process. The type 2 connector on the vehicle
will be unlocked. If you are charging at a type
2 charging station, the connector will also be
unlocked at that end.
• Remove the type 2 or the type 1 connector
from the vehicle.
• Remove the mains adapter.
• Disconnect the JUICE CONNECTOR safety
adapter from the JUICE BOOSTER 2 if
preferred. To do this, pull the retaining ring
on the JUICE CONNECTOR coupling back
and pull the connectors apart.
13.4. Selecting / changing the
operating mode (MODE)
You may need a different charging mode
depending which country you are charging your
electric car in. The factory setting is Standard
mode. Proceed as follows to change the mode:
• After connecting to the mains – before
plugging into the vehicle or up to 30 seconds
after – hold the SELECT button (F) down for
5 seconds until all the LEDs flash yellow.
Afterwards only one LED will flash yellow.
This indicates the current mode set.
• Press the SELECT button repeatedly until the
desired mode is reached in accordance with
the diagram below. The selected mode will
be saved automatically after approx. 5
seconds.
• Please check out the modes and their use on
the following table:
ENGLISH
51

Werbung

loading