elv FAZ 3000-PIR Bedienungsanleitung Seite 15

The LED on the sensor illuminates briefly, the base station emits a short signal
tone as confirmation of reception.
· Close the housing of the PIR transmitter; a clearly audible click indicates that it is
closed.
· Go to the base station, which displays the following:
motion
_
· Use the keyboard to enter the name of the sensor:
· Several letters are printed on the keys. The letters are accessed by pressing the
key several times.
· Two seconds after the last key press the cursor jumps to the next figure.
· Use "Menu a/A" to switch between upper and lower case.
· Press "0∪" for a space.
· Press "←C" to delete a letter entered by mistake.
· Press "OK" to finish entering a name, the following appears on the display:
Clos.:
intern:
· Use the "→" key to set: Internal sensor Y/N (yes/no).
· Use the "↑" key to set the closure group.
Clos.:
intern:
· Use the "→" key to set: Closure group Y/N (yes/no).
· Press the "OK" key to set the sensitivity. The response sensitivity can be set in the
range 1 to 4, with 4 being the highest sensitivity. The unit is factory set to value 3.
Use the "↑" and "↓" keys to select the required value.
sensiv.: 3
· Press the "OK" key to register the next sensor.
· Additional PIR transmitters are registered as described in the paragraphs above.
· When all PIR transmitters are registered, the procedure is terminated by pressing
the "←C" three times.
X
N
Y
N
Y
15