ATOMSTACK A6 PRO Montageanleitung Seite 26

4)When enabling this function, there are two functions:
a) Auxiliary material placement;
b) Positioning, the laser will move to the position of the cross laser
light when starting engraving.
5)The auxiliary positioning factory turns off this function by default,
the A6 does not have the auxiliary positioning function, and A12/A24
models have the auxiliary positioning function
3.2 How to enable the auxiliary positioning function in LightBurn
The auxiliary positioning function is turned off by factory default. You
can enable the auxiliary positioning function through the display screen
or the APP. The auxiliary positioning function is already enabled when
using LightBurn, so there is no need to make any settings.
Current Position
23
3.3 How to enable the auxiliary positioning function in LaserGRBL
1)
In the toolbar below, right-click in a blank area to open the "Add
Custom Button" window, then click "Add Custom Button".
2)Enter [ESP501] in "GCode" and enter the button name in
"Caption" and "Tool Tip". You can customize the button image
on the left. Click "Create" to generate a custom button with the
corresponding function.
4 1
2
3
Add Custom Button
1
4
5