ATOMSTACK A6 PRO Montageanleitung Seite 23

4. Determine the engraving position.
4.1 Set the current position as the starting point for engraving.
4.2 Click the "Outline Scan" button, and the laser will begin scanning the outer contours of the pattern on the computer. You
can change the position of the engraving object based on the scanned outer contours. Additionally, you can click the
"Surround" button multiple times until the outer contour is in the desired engraving position.
1 2
5. Start and stop engraving.
Start
Stop
20