ATOMSTACK A6 PRO Montageanleitung Seite 25

1.Tilt Detection
Operating method:
1.1 Click to enable the function. When the machine tilts at an
angle between 15° and 20° with the horizontal plane, the function
will be triggered: the machine automatically stops working, the
buzzer sounds, and there will be an alarm prompt on the PC side.
1.2 Deactivate the alarm:
The machine will automatically deactivate the alarm when it
returns to a level position.
2.Resume Engraving
2.1 Precautions:
1) "Resume Engraving" can only be used through an offline display
screen or an APP.
2)
After enabling the resume engraving function, the motor will be
locked. Do not manually move the laser module forcefully.
3)Ensure that the engraving machine and the object to be
engraved have no displacement after a power failure, as it may
cause deviations in the engraving.
4)During the process of resuming engraving, please do not insert
or remove the HDMI cable, otherwise, you will need to restart the
machine to enable this function.
5) Make sure the "Auto-home on startup" is turned off, as it may
affect the normal use of the resume engraving function.
Introduction to the basic functions of offline
2
Basic Settings
3. Auxiliary Positioning
3.1 Notes:
1)Auxiliary positioning can only be calibrated through an offline
display screen or an APP. The PC side can only use this function, can
not calibrate the positioning, if you need to position accurately, you
need to calibrate through the display/APP first;
2)If the machine is not moved or the laser is not disassembled, there
is no need to repeat the positioning. However, if the laser is
disassembled or the machine is moved, repositioning is required for
precision.
3)When exporting the .gc file in LightBurn, the current position must
be selected as the starting point in the bottom left corner for
accurate positioning.
22
Auto-home on startup
1
3