Hyundai HHA592201 Benutzerhandbuch Seite 2

ASSEMBLING THE CORDLESS VACUUM CLEANER
1. Assembling the aluminum tube
Fit the tube onto the main body's air inlet until it clicks into position.
If need to remove the tube, hold the main body, press the release knob
and remove the tube.
ASSEMBLING THE ELECTRICAL FLOOR BRUSH
2. Fit the electrical floor brush onto the tube until it click into the
position. If need to remove the electrical floor brush, hold the aluminum
tube, press the floor brush release knob and remove the brush from the
tube.
3. ASSEMBLING THE 2 IN 1 BRUSH
Fit the accessory on the main body's air inlet and/or on the tube until
it clicks into position. The 2 in 1 brush is good for cleaning stairs,
corners.
OPERATING THE CORDLESS VACUUM CLEANER
Before first time use, ensure the vacuum cleaner has been charged
4-4.5hours. Turn on the Cordless vacuum cleaner by pressing the ON/
OFF button. Note: Battery indicator light represents battery capacity
and will illuminate during use. The indicator light will turn off one by
one as the battery runs out. Warning: Do not use the Cordless Vacuum
without the removable filter or dust bin in position.
CHARGING PRODUCT
1.Turn off the Cordless vacuum cleaner.
2.Connect the adapter to the charge port on the main unit.
3.Plug the adapter into the main power supply.
The battery indicator display light will flash in a ring. Once the battery
is fully charged, the battery indicator lights indicated by the battery are
always bright in a ring.
CARE AND MAINTENANCE
1. Turn off the Cordless vacuum cleaner
2. Press and hold the dust cup release button and rotate the dust cup
at a clockwise angle of 30 °, then remove the whole dust cup.
3.How to clean the dust cup
Without removing the dust cup. Press the dust cup release button
directly, Then drop the dust into waste container.(fig. A)
Or you can remove the dust cup and Press the dust cup release button
directly, Then drop the dust into waste container.(fig. B)
4.Remove filter assembly: Filter, Hepa , Dust cup.
5.Cleaning the filter/hepa in water, wait for it to dry comple
tely.
6.Put the filter/hepa back into the dust cup carefully.
7.Put the dust cup back into the main body: Dust cup counterclockwise
rotation into the slot, hear the sound of «ka», that means the dust cup
installed in place.