Technical Data - Aleapow O2 Bedienungsanleitung

• Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges
are less likely to jam and are easier to control.
• Prevent overheating of the device and the work piece. Excess heat may dam-age the tool
and the device.
• Never use power tool near flammable materials. Sparks may set fire to these materials.
• Keep the handles dry and free of grease. Slippery handles can lead to accidents.
• Do not use accessories that have not been designed and recommended by the manufac-
turer for this specific power tool. Just because you are able to attach an accessory to your
power tool this does not guarantee that it is safe to use
• The permitted revolutions of the tool must be at least as high as the highest revolutions
specified on the power tool. Accessories that rotate faster than they are permitted to may break
and fly and thus cause injuries.
• Remember that moving parts may also be located behind ventilation and venting slots.
• Symbols affixed to your unit may not be removed or covered. Information on the unit that is no
longer legible must be replaced immediately.
Before putting the unit into operation, read and observe the instructions for use.
Risk of damage to the eyes! Never look directly into the LED.

Technical data

Chuck size
Charging time
Battery Type
USB Output data
Torque
Speed
Voltage
- 06 -
6.35mm
5Nm
200 / min
3-4hr
3.6V
Li-ion
DC5V, <2A