Viribus ATB-C024-GE Benutzerhandbuch Seite 7

2. Installing the Rear Wheels
Note: The two rear wheels ARE different and should NOT be mixed up. The D-shaped
wheel (2) goes with the D-shaped axle while the O-shaped wheel (3) goes with the
O-shaped axle.
1. Remove the nut and washer from the D-shaped axle. Put them nearby.
2. Insert the D-shaped axle into the D-shaped hole on the wheel.
3. Replace the washer and nut.
4. Tighten them with an adjustable wrench.
5. Remove the nut and washer from the O-shaped axle. Put them nearby.
6. Adjust the gasket on the O-shaped axle. Insert the O-shaped axle into the O-shaped hole
on the wheel.
7. Replace the washer and nut.
8. Tighten them with an adjustable wrench.
5