Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The modes of DMX 512 data are shown via the DMX indicator.
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the control LED lights up permanently.
If there is no data received at the DMX-input, the control LED will be off.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective,
- the cable or connector is defective or the signal wires are not properly connected with the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX-protocol
Control-channel 1 - Rotation
Value
000 - 007
No rotation
008 - 123
Clockwise rotation with increasing speed
124 - 131
No rotation
132 - 247
Counter clockwise rotation, decreasing speed
248 - 255
No rotation
Control-channel 2 - LED effects
Value
000 - 005
Blackout
006 - 050
Color-change
051 - 100
Fade
101 - 150
Color-change + strobe I.
151 - 200
Cross-fade
201 - 255
Color-change + strobe II.
Control-channel 3 - LED Speed
Value
000 - 255
Increasing speed
CLEANING AND MAINTENANCE
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tightly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
Feature
Feature
Feature
22/23
00071059.DOC, Version 1.0
Werbung
