Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Control Board
The Control Board offers several features: you can e. g. easily set the starting address.
Enter the menu by pressing the MODE-button. You can change the selection by pressing UP or DOWN.
Press ENTER in order to select the desired menu. You can leave every mode by pressing the MODE-button.
The functions provided are described in the following sections.
The display shuts off after approx. 30 seconds of inactivity. With the touch of a button it lights up again.
LED Display
ADDR
MODE
PRCO
SPCO
SPMO
DMX-controlled operation
You can control the devices individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED BR-200 will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each device correctly and
independently from any other fixture on the DMX-chain.
If several LED BR-200 are addressed similarly, they will work synchronically.
Press the MENU-buttons and the UP/DOWN-buttons for setting the desired starting address. Now you can
start operating the LED BR-200 via your lighting controller.
Note:
DMX address setting
001 - 512
With this function, you can set the desired
DMX 512 address via the Control Board.
DMX mode setting
the device will automatically detect whether
M – DM
DMX 512 data is received or not. If there is
no data received at the DMX-input, the
control LED will flash.
Automatic program mode
M – AU
With this function, you can adjust the Auto
mode.
Sound-controlled mode
M – SO
With this function, you can adjust the sound-
controlled mode.
Slave mode
M - SL
With this function, you can set the Slave
devices.
Built-in program setting
You can run the internal programs via "PR.
1-8".
PR 1 - 8
Pr. 1 – 4 switching
Pr. 5 – 7 fading
Program 8: Endless loop from programs 1-7
Program speed setting
SP01 - 15
With this function you can set the program
speed. 01 is maximal speed/15 is minimal
speed
Motor speed setting
SP1 – 6
With this function you can set the motor
speed.
Function
21/23
00071059.DOC, Version 1.0
Werbung
