GreenWorks CSE405 Bedienungshandbuch Seite 8

EN
Problem
The motor runs
and the chain ro-
tates, but the chain
does not cut.
The machine does
not start.
The motor runs,
but the chain does
not cut correctly,
or the motor stops
after around 3 sec-
onds.
Possible cause Solution
Sharpen or replace
The chain is blunt.
the saw chain.
Turn the chain
The chain is in the
loop to the other
incorrect direction.
direction.
The chain is tight Adjust the chain
or loose. tension.
Pull the chain
The chain brake is brake in the direc-
engaged. tion of the user to
disengage it.
Make sure that the
The machine and
battery release
battery are not
button clicks when
connected correct-
you install the bat-
ly.
tery pack.
The battery level Charge the battery
is low. pack.
1. Push the lock-
out button and
The lock out but-
hold it.
ton and the trigger
are not pushed at
2. Push the trig-
the same time.
ger to start the
machine.
Refer to battery
The battery is too
and charger man-
hot or too cold.
ual.
Release the trigger
The machine is in
and start the ma-
the protection
chine again. Do
mode to protect
not force the ma-
the PCB.
chine to cut.
Charge the battery.
Refer to the bat-
The battery is not tery and charger
charged. manual for correct
charging proce-
dures.
Lubricate the
chain to decrease
the friction. Do
The chain is not not let the guide
lubricated. bar and the chain
operate without
sufficient lubri-
cant.
Cool the battery
Incorrect battery
pack until it de-
storage tempera-
creases to the am-
ture
bient temperature.
English
8 TECHNICAL DATA
Voltage
No load speed
Guide bar length
Chain stop
Chain oil capacity
Weight (without battery
pack)
Measured sound pressure
level
Guaranteed sound power
level
Vibration
Chain
Guide bar
Battery model
Charger model
9 WARRANTY
(The full warranty terms and conditions can be found on
Greenworks website https://www.greenworkstools.eu)
The Greenworks warranty is 3 years on the product, and 2
years on batteries (consumer/private usage) from the date of
purchase. This warranty covers manufacturing faults. A faulty
product under warranty might be either repaired or replaced.
A unit that has been misused or used in other ways then
described in the owner's manual might be rejected for
warranty. Normal wear, and wear parts are not considered as
warranty. The original manufacturer warranty is not affected
by any additional warranty offered by a dealer or retailer.
A faulty product must be returned to the point of purchase in
order to claim for warranty, together with the proof of
purchase (receipt).
10 EC DECLARATION OF
CONFORMITY
Name and address of the manufacturer:
Name:
Address:
Name and address of the person authorised to compile the
technical file:
Name:
10
2X24 V DC
20 m/s
350 mm
< 0.12 s
180 ml
3.7 kg
L = 94 dB(A), K
pA
dB(A)
L = 108 dB(A)
wA.d
2
2.7 m/s , K = 1.5 m/s
90PX052X/CL14352
144MLEA041/
M1431452-1041TL
G24B2, G24B4 and other
BAG series
G24C and other CAG series
GLOBGRO AB
Globe Group Europe
Riggaregatan 53, 211 13 Malmö, Sweden
Peter Söderström
= 3
pA
2