Wellcare MHB10 Gebrauchsanleitung Seite 12

EN
1. The rechargeable battery pack must be fully
charged (for at least 5 hours) before being used
for the first time or not having been used for
a long time. One single fully charge allows you
to use this heating belt 5 hours at the highest
temperature setting.
2. Always charge the battery pack in a dry
environment at normal room temperature and do
not let the battery pack be covered by any
objects.
3. In order to charge the battery pack, connect
the charger(1) to the battery pack(2) first, then
connect the charger(1) to the wall socket. During
the charging process, green LED will flash.
4. When the battery pack(2) is fully charged, the
green LED will keep lighting up. Remove the
charger(1) from the wall socket and disconnect
the battery pack (2) from the charger(1).
5. If you want to check the state of charge of the
battery pack(2), you may press the power switch
button. Please make sure the battery pack(2)
is not connected to the heating pad(3) nor the
charger(1) :
- If the green LED lights up constantly for 3
seconds, the state of charge is more than 25%
- If the green LED flashes 3 times in 1 second,
the state of charge is below 25%. Please
recharge the battery pack before using it.
6. Please note that the battery pack must be
protected against extreme weather (such as
placing it under clothing in very cold weather) to
maintain its performance.
7. The battery pack should be charged at least one
12