Technics SA-5370 Serviceanleitung Seite 5

@ TO REMOVE CABINET
1. Loosen two (2) metal clamp-
mounting screws, nos. © and ©
as shown in fig. 4.
2. Remove four (4) cabinet-mount-
ing screws ( @ ~ @®), as shown
in fig. 5.
3. Remove cabinet from chassis.
4. When installing the front panel,
insert the cabinet edge into grove
of front panel as shown in fig. 6.
only set for [XA, XAL]
Fig. 5 | Fig. 6
Set Rear Panel
Fig. 4
Fig. 7
(A) For adjustment with DC voltmeter
1. Turn the speaker switch "OFF".
2. Connect the DC voltmeter as shown in ''Alignment Points'. (Fig. 1)
1. Turn OFF the power supply for the set.
SA-5370