Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
Place the heater on a flat level surface and ensure that the air intake and air
1.
outlet are clear of obstruction.
2.
Insert the plug into a 220V-50Hz power outlet.
Move the ON/OFF SWITCH at the rear of the unit to the on (I) position.
3.
4.
Press the POWER button on the control panel to turn the heater on.
5.
Press the MODE button to adjust the work mode. It default to H for 1500 W,
press it to change to M for 1200 W and press once again to set to L for 1200
W but with lower fan speed. The LED lamps show in Red.
6.
The PTC will stop working when the thermostat temperature setting (28 °C
for H MODE, 23°C for M MODE and 18 ° C for L MODE) is reached. It will come
back for working when the room temperature is below the thermostat setting.
Press SWING button to turn on/off oscillation.
7.
8.
Press the TIMER button to set up the timer hours as below:
1hour, lamp 1
2 hours, lamp 2 on
3 hours, lamp 3 on
4 hours, lamp 1 and lamp 3 on
5 hours, lamp 2 and lamp 3 on
6 hours, lamp1, 2 and lamp 3 on.
9.
Press the MODE button again in L mode of heat mode to activate FAN MODE,
then the H LED lamp will be on and show in blue. Press mode button once
again to set the fan model to be in M and L mode.
10.
Move the ON/OFF SWITCH at the rear of the unit to the off position (O). Turn
the power off and disconnect the plug from the power outlet when not in use.
Care and cleaning
CAUTION: Disconnect power cord before servicing.
1.
Ensure that the heater is turned off (the switch on the back of the unit should
be in the offposition) .Unplug the power cord from the wall outlet before clea-
ning.
6
Werbung
