Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Basic Operation
2.1 Power ON
After correct installation and power on, the power indicator will be lighted, DVR automatic power on. Buzzer will make beep sound
after starting up, enter into multi-picture monitoring status, you can make operations and configuration now. DVR will start recording
if within set record time.
Main Menu introduction.
2.2 Power OFF
Method 1: Enter shut down interface [Main menu] > [Shutdown] > [Shutdown]，select [Shutdown]
Method 2: Long press [POWER/SCREEN] on the front panel
2.3 ON/OFF Screen
1.
Short press [POWER/SCREEN] on the front panel or press [SCR] of remote control to turn on/off the screen.
2.4 Network Access
2.4.1 Network Setting
[MAIN MENU] > [CONFIGURATION] > [NETWORK]，enter setting interface.
Cautions: if DHCP server exist in the network, please select "automatic obtain IP address" it'll be
advised. Otherwise, users can configure "IP, subnet mask, Gateway and DNS according to the need.
[ network card ] users can select it according to your own requirements.
[ IP address ] To set IP address, default IP address:192.168.1.88.
[subnet mask] To set subnet mask of device. default subnet mask:255.255.255.0.
[default gateway] to set default gateway of device, default gateway:192.168.1.1. Network configuration interface
[DNS configuration] DNS, analyze domain name to IP address, the address is provided by your local
network operators
.
2.4.2 Browser Access
Please make sure that the DVR is connected to the network correctly first.
Werbung
