Avtech AVH312 Bedienungsanleitung Seite 24

5.4 PTZ Control (All CH mode)
Note: This function is available only for "SUPERVISOR" and "POWER USER". To know more details,
please refer to "4.4 User Level Creation" at page 12.
Click on the quick menu bar to display the panel as follows:
/ / /
/
/
/
/
*To know how to configure NVR with video server, please refer to the user manual of video server.
5.5 IP Device Search
Note: This function is available only for "SUPERVISOR". To know more details, please refer to "4.4 User
Level Creation" at page 12.
Click (IP Search) to start search IP camera(s) connected in the same network segment as the NVR (i.e.
10.1.1.xx by default).
You'll see the list of every connected IP camera with its connection status to this NVR and MAC address.
IP PORT
10.1.1.12 88
10.1.1.13 88
10.1.1.14 88
10.1.1.15 88
10.1.1.16 88
10.1.1.17 88
10.1.1.18 88

All manuals and user guides at all-guides.com
Up / Down / Left / Right Click to move your selection up / down / left / right, or change settings.
Click to confirm your selection / enter the menu.
Enter
This two buttons are designed for PTZ camera. To know the action after
Iris + / Iris -
clicking Iris + and Iris -, please refer to the camera's user manual. If you
using an analogue camera, paired with Video Server*, make sure the
camera and Video Server support P-D / P-P protocol for PTZ control.
Click to zoom in on the image to the largest / zoom out on the image to its
Zoom in / out max
original size.
Zoom in / out Click to zoom in / out the image.
Focus near / far Click to adjust the focus of the image.
Click to activate the auto pan.
Auto pan
Before using it, you need to assign a specific function that will be enabled
when "AUTO" is clicked. For details, please refer to the user manual of
the PTZ camera.
Click to activate the auto tracking.
Auto tracking
Before using it, you need to assign a specific function that will be enabled
when "AUTO" is clicked. For details, please refer to the user manual of
the PTZ camera.
Click to enter the PTZ preset point you want to see.
Preset point
Click to enter the camera main menu.
Camera Menu For details about each camera menu, please refer to the user manual of
the PTZ camera.
IP SEARCH
MAC STATUS
00:0e:53:e5:9a:f1 CONNECTED TO CH1
00:0e:53:a6:91:18 CONNECTED TO CH2
00:0e:53:a5:9f:a2 UNUSED
00:0e:53:e1:4e:k5 CONNECTED TO CH3
00:0e:53:s5:3e:h6 CONNECTED TO CH4
00:0e:53:e6:4b:26 CONNECTED TO CH5
00:0e:53:g2:3b:e7 CONNECTED TO CH6
CONNECT SETUP EXIT
18
QUICK OPERATION