Candy BWM 1410PH7R/1-S Bedienungsanleitung Seite 60

After starting the washing machine
you need to wait a few seconds before
the appliance starts the programme.
CYCLE DURATION
l
When a programme is selected the
display automatically shows the cycle
duration, which can vary, depending on
the options selected.
l
Once the programme has started you will
be kept informed constantly of the time
remaining to the end of the wash.
l
The appliance calculates the time to the
end of the selected programme based
upon a standard loading, during the cycle,
the appliance corrects the time to that
applicable to the size and composition of
the load.
ADD OR REMOVE ITEMS AFTER THE
PROGRAMME HAS STARTED (PAUSE)
l
Press START/PAUSE (the display shows
PAUSE).
Ensure that the water level is below
the porthole before opening it, to
prevent any flooding.
l
After adding or removing items, close the
porthole and press START/PAUSE (the
programme will resume from when it was
interrupted).
CANCELLING THE SET PROGRAMME
l
To cancel the programme, press the
ON/OFF button for about 2 seconds until
the display switches off.
OPTION area
The options must be selected before
pressing the START/PAUSE button.
- TEMPERATURE SELECTION
l
By this option you can change the
temperature of the washing cycles.
To prevent damage to the fabrics, it is
not possible
temperature
value set for each programme.
- SPIN SELECTION
l
By this option you can reduce the
maximum spin
programme, until it is completely excluded.
l
If the label
instructions,
maximum speed set for the programme.
To prevent damage to the fabrics, it is
not possible to increase the speed
over the maximum one set for each
programme.
l
It is possible to modify the spin speed at
any time, without shifting the machine to
PAUSE.
An over dosing of detergent can
cause excessive
appliance detects the presence of
excessive foam, it may exclude the
spinning phase or extend the duration
of the programme and increase water
consumption.
The machine is fitted with a special
electronic device, which prevents the
spin cycle
unbalanced.
vibration, improves noise reduction and
prolongs the life of the washing
machine.
- DELAY START
l
By this option you can programme the
start of the washing cycle.
l
Selecting the dedicated icon by the
"SET" button you can set a delay from 1
hour to max. 24 hours.
l
Confirm pressing the "SET" button.
60
to increase
above the maximum
speed for the
does not show
you can spin
foaming. If
should the load
This reduces
the
set
any
to the
the
be
the