Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7. CONNECTION TO THE MAINS
1
. Ensure that mains voltage and frequency are the same as those stated on the rating plate
2.
to the appliance.
Ensure that the supply socket:
rated current as set out on the rating plate;
switch with In = rated value as stated on the rating plate;- differential with Id sensitivity=30 mA. . Ensure
that there is no danger of explosion (AD) in the room. . Make sure the environment is suitable for the
power supply cable provided. The cable of the appliance is H05 VVF, designed for internal use.
the plug in the socket (do not use three-way adapters and reduction adapters) (see fig. 5).
8. CONTROLS
The appliance features controls situated in a protected panel on the front side.
the temperature in the appliance.
3. Heating lamp switch:
to switch on the heating lamps.
cover - Position II to lift - Position O to stop - Position I to lower.
lamps off ten minutes before lowering the cover. Press button
temperature set-point, which can be changed by pressing button
6).
9. CHECKING CORRECT OPERATION
Make sure that: 1
. plug is connected; . cover is open; . resistor switch is on (green light lit up);
4.
5
heating lamps are on; . Check that the set temperature is correct. . Keep the machine away from
inflammable material or any danger of explosion.
10. CLEANING THE BASIN
1
. Turn off the power switch and pull the plug out of its socket. . Clean the basin with a soft,
SPONGE DO NOT USE WATER. 3
appliance to the power supply.
11. REPLACEMENT OF THE LAMP
1.
. 2 Warning:
Turn the appliance off
to take hold of it and replace it.
towards one of the two supports in order to release the other end and then take it off of the lamp set.
5. Refit all parts by following the above instructions in reverse order (see fig. 7).
Operator's guide
a)
complies with the IEC regulations:- thermal-magnetic
c)
2. Basin resistor switch:
2
. Carefully dry each item with a dry, clean cloth. . Reconnect the
.
never handle the new lamp with bare hands. Use a piece of paper
3.
Remove the protection grids by sliding it sidewards. . Press the lamp
7
is properly earthed;
b)
fulfils the requirements of the
4
1. Thermostat: t
to switch on the resistors of the basin.
4. Cover lifting switch: t
N.B.:
turn the heated shelves and heating
8 "SET or P"
once to display the
9 "UP"
or button
3
6
2
(A)
attached
3
5.
Insert
o adjust
o open and close the
10 "DOWN"
(see fig.
DAMP
4
4
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO
Werbung
