Somogyi Elektronic HURRICANE Serie Bedienungsanleitung Seite 8

FITTING THE BUTTERFLY-VALVE
Hold the butterfly-valve in hand and adjust it to the exhaust outlet, as shown on the image. Fit the butterfly-valve into
position and turn until the three claws of the valve seize. Installation is now complete. The mounting type of outside air
baffles and of butterfly-valves must comply with the requirements of the IEC/EN 60335-1 standard.
REPLACEMENT, INSTALLATION OF THE CARBON FILTER
• Remove the grease filter.
• The carbon filter is located on the drive motor. Turn the carbon filter until unscrewed.
• Replace the carbon filter with a new one, and reassemble the unit by performing the above steps in reverse order.
Warning: The carbon filter is not washable or recyclable. It needs to be replaced after approximately 2–3 months of use.
TROUBLESHOOTING
Fault
Light is lit, but drive motor does
not run.
Neither the lighting, nor the drive
motor run.
Oil leak present.
Vibration occurs.
Insufficient suction.
The appliance is askew.
Cause
The blades are blocked.
The condenser is damaged.
The drive motor is damaged.
The internal wiring of the drive motor is cut off /
disconnected. There is an unpleasant smell present. Replace the drive motor.
In addition to the above, check the following:
The lighting is damaged.
The supply cable is loosened.
The outlet and the inlet of the vent are not sealed
properly.
The blade can cause vibration, if damaged.
The drive motor is not fastened tightly.
The exhaust hood is not fastened tightly.
The distance between the exhaust hood and
cooktop is too big.
Too much ventilation due to opened doors or
windows.
Mounting bolts are not tightened enough.
Hangers are not tightened enough.
Open
Close
Check the blades.
Replace the condenser.
Replace the drive motor.
Replace the lamps.
Connect the cable according to the wiring diagram.
Remove the outlet and seal with adhesive sealant.
Replace the blade.
Fasten the drive motor tightly.
Fasten the exhaust hood tightly.
Readjust the distance.
Select a new location for the installation of the
appliance, or close some of the doors/windows.
Tighten the mounting bolts and adjust the appliance
horizontally.
Tighten the hangers and adjust the appliance
horizontally.
8
Solution