Somogyi Elektronic HURRICANE Serie Bedienungsanleitung Seite 7

OPERATION
DRIVE MOTOR SWITCH: Press this switch to stop the operation of the drive motor.
ENGINE SPEED SWITCH: By pressing this switch the drive motor changes to LOW speed (rpm) operation.
ENGINE SPEED SWITCH: By pressing this switch the drive motor changes to MEDIUM speed (rpm) operation.
ENGINE SPEED SWITCH: By pressing this switch the drive motor changes to HIGH speed (rpm) operation.
LIGHT ON/OFF SWITCH: Press to turn the lighting on, and press again to turn off.
LIGHTING
REPLACING THE LAMP
• Turn off the exhaust hood and disconnect the plug from the mains socket, or switch off the cut-out, or fuse.
• Remove the grease filter.
• Apply tension on the lamp and remove it from
its holder (this might require the exertion of
pressure or force).
• Disconnect the lamp connector.
• Replace the lamp with a new one of equivalent
type, and ensure that it is correctly connected to
the connector.
• Reconnect the power supply by plugging the
supply cable plug into the wall socket, or by
switching the cut-out, or fuse back on.
Maximum output
With built-in adapter
LED-modules
INFORMATION
!
Regularly clean the ventilation fans. Prevent the accumulation of thick grease on the fan blades.
CLEANING AND MAINTENANCE
Before cleaning, maintenance or servicing, disconnect the kitchen exhaust hood from the power supply.
• Regularly clean the surfaces of the exhaust hood. To clean the exhaust hood use mild soap or detergent.
• Avoid using strong bases or scrubbing materials.
• Avoid using scrubbing materials and dish-washing liquid.
• The metal grease filter can be cleaned using mild soap or detergent. (Strong deposits of grease are difficult to remove and the filter might need
to be replaced.)
• The activated carbon filter cannot be cleaned, it needs to be replaced regularly.
Information
!
Do not allow water to enter the electrical parts of the drive motor, the control switch, etc. during cleaning.
It is recommended to clean the metal grease filter every three months, according to the following
instructions:
• Remove the metal grease filter from the kitchen exhaust hood and clean it in a solution of water
and mild liquid detergent. Let soak.
• Rinse thoroughly with hot water and let dry completely.
• The colour of the metal grease filter may change after it was cleaned several times. This is no
reason for raising complaints, or to replace the metal grease filter.
Information
!
Failure to carry out the cleaning procedure as instructed will cause a risk of fire.
Voltage
1,5 W 220 V-240 V
Rectangle:
33,2 mm x 120 mm
7
Lamp base ILCOS D code
DBS-1.5-H-33.2/120