Somogyi Elektronic HURRICANE Serie Bedienungsanleitung Seite 6

Preparation of Installation:
Before the commencement of installation works, ensure that the appliance is disconnected from
power supply. The plug should be positioned to ensure easy disconnection and connection.
The help of two persons will be required to install the exhaust hood. The following tools and materials
will be required to complete installation.
Required tools:
• Drill suitable for the type of wall
• Phillips head screwdriver
• Measuring band
• Kitchen saw or jigsaw
• Installation and electrical connection should be performed by a qualified person, with he observation
of all applicable rules and standards, also including the consideration of fire-resistance.
• Do not vent the extracted air into to the flue (chimney) of other appliances using gas, or other
combustible fuels.
• Always observe the requirements applicable to air discharge.
• The kitchen exhaust hood should be positioned at a height of at least 65cm, and up to 75cm from
the cooktop.
INSTALLATION INTO CABINET
• Drill a hole of 130mm diameter and four holes of 3.5mm diameter arranged, as shown on the image
below.
• Warning: Failure to follow these instructions for the installation of bolts and the fastening device
may result in electric hazards.
• CAUTION: If the kitchen exhaust hood will be used in recycling ventilation mode, the 130 mm
diameter hole is not required.
• Fasten the exhaust hood to the kitchen cabinet using the 4 bolts. Temporarily fitting the exhaust
hood, check the correct position of mounting bolts. If correct, set the appliance into position. Tighten
the bolts, if needed.
INSTALLATION ON WALL
• To mount the exhaust hood on the wall, drill the top two holes of 10mm diameter at a distance of
538 mm, symmetrical to the exhaust outlet in the middle, as shown on the image below. Ensure that
the exhaust hood is positioned exactly above the cooktop.
• Fit two plastic dowels (included) into the holes.
• Place two bolts into the top two dowels, and tighten them so that they protrude by 3mm from the
wall surface.
• Hang the kitchen exhaust hood on the top two bolts and mark the position of the two bottom bolts.
• Remove the exhaust hood from the wall, drill the two bottom holes, then fit the plastic dowels into
the holes.
• Hang the exhaust hood on the top two bolts, fit the bottom bolts and tighten them all.
6