Somogyi Elektronic HURRICANE Serie Bedienungsanleitung Seite 5

INSTALLATION
DRILLING AND MONTING THE BRACKET
• Carefully read the instructions for use.
• Remove the exhaust hood from its packaging and verify the operation of all of its functions. Verify, whether the rated voltage (V) and frequency
(Hz) indicated on the product label is equivalent to the supply voltage and frequency available at the installation site.
• Ensure there is no electric wiring, piping, etc. behind the mounting surface to be drilled.
• Stainless steel and glass surfaces of the exhaust hood can easily get damaged, if scratched or impacted by the tools during installation. Pay
attention to the protection of these surfaces during installation.
• Protect the surface of the cooktop below with a sheet of cardboard paper or similar means, to avoid causing any damage during the installation
of the exhaust hood.
• The manufacturer does not take responsibility for failure to observe safety regulations applicable to the correct and normal use of electric
appliances.
Select the Ventilation Mode:
External ventilation mode
INFORMATION
!
• Adequate combustion and gas exhaust requires the presence of a sufficient amount of air in the flue (chimney) of appliances using combustible
fuels, in order to prevent reversed air-flow.
• In the course of evaluation of air-pressure, the entire ventilation system of the house/flat needs to be considered.
• Authority regulations applicable to the delivery of extracted air must be observed. If the exhaust hood is used in recycling ventilation mode with an
activated carbon or cotton filter, no limitations apply to the operation of the appliance.
• If external ventilation mode is preferred, two types of ventilation methods are possible, by "horizontal connection" and "vertical connection". Use a
suitable too to remove the cover, and install the butterfly-valve into the opening before use.
• The square-shaped butterfly valve required for "horizontal connection" is not included in the supply.
Recycling ventilation mode
5
Position of circulation selector lever
External ventilation mode:
By turning the circulation selector
lever in this direction, external
ventilation can be selected.
Recycling ventilation mode:
This position of the ventilation
mode selector lever selects indoor
recycling ventilation.