Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Use:
Raise the table above to the required working height and insert the pins. Take care that these are
placed correctly. The pin must be pushed towards the frame of the press until the lock ring on the pin
meets the frame. Lower the table down on the pins and place the straightening blocks and the press is
ready for use.
Please note ! From 40% of the max. pressure and up to max. pressure the item must always be
supported by both of the straightening blocks.
DO NOT use the press beyond the indicated max. pressure and max. length of stroke as this may
cause damage to the seals in the cylinder.
* Lift of table2:
Mount the ring in
the piston. Place
the chain
through the ring
3/5
* Lift of table :
Place the chain around
the table supports as
shown
2005.04.22
Werbung
