Cisco Systems Linksys WPC55AG Kurzanleitung Seite 8

Connect the Dual-Band
2
Wireless A+G Notebook Adapter
A
Power down your notebook
and locate an available
CardBus slot on it.
B
With the connector pin end
facing the CardBus slot and
the label facing up, slide the
Adapter into the CardBus slot
until it locks into place.
C
Power on your notebook
computer. The Power LED
should light up when the
Adapter is installed correctly.
D
If you are using Windows 2000,
you may see a screen
indicating that a digital
signature was not found. This
software has been tested and
works properly with Windows
2000. Click the Yes button.
E
After the Adapter is installed,
the Wireless Network Monitor
icon will appear in the system
tray at the bottom right-hand
corner of your screen.
Double-click the icon if you
want to check the link
information, search for
available wireless networks, or
make additional configuration
changes.
Congratulations! The installation of
the Dual-Band Wireless A+G
Notebook Adapter is complete.
8
All manuals and user guides at all-guides.com
B
D
For additional information or troubleshooting
help, refer to the User Guide on the CD-ROM
or the Technical Support Insert. You can also
e-mail for further support.
Website
http://www.linksys.com/international
Linksys is a registered trademark or trademark of
Cisco Systems, Inc. and/or its affiliates in the U.S.
and certain other countries. Copyright © 2005
Cisco Systems, Inc. All rights reserved.
WPC55AG-EU-LA-UK_V1.2-QIG-50110NC JL
E