IKAR ASS-4 Bedienungsanleitung Seite 18

GB
IKAR cantilever arm and IKAR fall arresting device with rescue lift
IKAR fall arresting device (HRA) with rescue lift
device as component:
One IKAR fall arresting device with rescue lift device
(HRA-type) can be fitted as described below.
Bolt the two mounting brackets to the cantilever
lower arm using the bolts provided. Insert HRA
device from above and lock into place with the
socket pin provided (
Pull out the socket pin from the upper arm locking
mechanism and fold the cantilever upper arm down.
Pull out the socket pin on the lower pulley and fold
the pulley out and upwards.
Pull the cable and snap hook through and lay in the
pulley. Then fold back the pulley and lock into place
with the socket pin.
On the top rope cover, pull out the socket pin and
fold the cover plate (
3
through and lay the cable in the pulley. Then close
the cover plate ( ) and lock in place with the socket
4
pin. Hook the snap hook into the eyelet.
Please note:
The cable of the fall arresting device
with rescue-lifting device (HRA) pulls in
automatically until the rescue lift function is activated.
Always observe the instruction manual and safety
instructions for the IKAR fall arresting devices (HRA)
with rescue lift device.
Equipment assembly
).
1
) up. Pull the carabiner
1
3
18
2
4
Similar to illustration