Replacing The Lamp; Closing The Door - AEG Electrolux SCS81805F0 Benutzerhandbuch

40
What to do if...
Problem
Temperature cannot be
set .
The temperature in the ap-
pliance is too low/high.
The temperature in the re-
frigerator is too high.
The temperature in the
freezer is too high.
There is too much frost.

Replacing the lamp

The appliance is equipped with a longlife LED interior light.
Only service is allowed to replace the lighting device. Contact your Service Center

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
Possible cause
FROSTMATIC or COOLMATIC
functions switched on.
The temperature regulator is
not set correctly.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Many products are stored at
the same time.
There is no cold air circulation
in the appliance.
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is
not set correctly.
Solution
Switch off FROSTMATIC or COOL-
MATIC manually, or wait to set
the temperature until the func-
tion has reset automatically. Re-
fer to "FROSTMATIC or COOLMAT-
IC function"..
Set a higher/lower temperature.
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
Wrap the food correctly.
Set a higher temperature.