Lenz Digital plus SILVER+PluX12 Information Seite 32

32 Information SILVER+PluX12 Decoder
4.10 Lighting effect at function outputs
The lighting effect for the function outputs A and B is set in CV60 and for the function outputs C and
D in CV62. If you wish to switch the effects with a function of the digital system, you can make the
allocations to functions F1 to F8 in CV61 (for function outputs A and B) and CV64 (for function
outputs C and D). The effects available are shown in the table of the supported CVs further below.
4.11 The S.U.S.I. interface
The sound and function interface concept for locomotive decoders was devised in 2002 in
cooperation with the company DIETZ. The purpose of the interface is to facilitate the particularly
easy connection of sound and other function modules to locomotive decoders.
The S.U.S.I. module receives information about the running notch, the status of the functions etc.
via the interface and reacts accordingly, for example the sound of a bell is played or the locomotive
sound changes.
The quality of these sound effects depends solely on the S.U.S.I. module and not on the locomotive
decoder!
4.11.1 Connecting a S.U.S.I. module
You may connect all sound and/or function modules to the S.U.S.I. interface which correspond to
the interface's specification. Four solder surfaces on top of the decoder serve for the connection of
a sound or function module (See Abb. 2, Page 3). The soldering surfaces are assigned in
accordance with the S.U.S.I. Interface specification. The cable colours given correspond to the
recommendations of this specification.