Herunterladen Diese Seite drucken

Axis Communications Q6052-E Installationsanleitung Seite 6

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 37
AXIS Q60-E Series
• Do not attempt to repair the product yourself. Contact Axis support or your Axis reseller
for service matters.
• Do not point the camera lens toward the sun or other high-intensity radiation sources
because this could cause damage to the camera.
• The power supply shall be plugged in to a socket outlet installed near the product and
shall be easily accessible.
• Use a limited power source (LPS) with either a rated output power limited to ≤100 W or a
rated output current limited to ≤5 A.
Transportation
NO TICE
TICE
NO
NO
TICE
• When transporting the Axis product, use the original packaging or equivalent to prevent
damage to the product.
Battery
The Axis product uses a 3.0 V CR2032 lithium battery as the power supply for its internal real-time
clock (RTC). Under normal conditions this battery will last for a minimum of five years.
Low battery power affects the operation of the RTC, causing it to reset at every power-up. When
the battery needs replacing, a log message will appear in the product's server report. For more
information about the server report, see the product´s setup pages or contact Axis support.
The battery should not be replaced unless required, but if the battery does need replacing, contact
Axis support at www.axis.com/techsup for assistance.
Lithium coin cell 3.0 V batteries contain 1,2-dimethoxyethane; ethylene glycol dimethyl ether
(EGDME), CAS no. 110-71-4.
WARNING
• Risk of explosion if the battery is incorrectly replaced.
• Replace only with an identical battery or a battery which is recommended by Axis.
• Dispose of used batteries according to local regulations or the battery manufacturer's
instructions.
Dome Cover
NO TICE
TICE
NO
NO
TICE
• Be careful not to scratch, damage or leave fingerprints on the dome cover because this
could decrease image quality. If possible, keep the protective plastic on the dome cover
until the installation is complete.
• Do not clean a dome cover that looks clean to the eye and never polish the surface.
Excessive cleaning could damage the surface.
www.a1securitycameras.com email: sales@a1securitycameras.com
Available from A1 Security Cameras
6

Werbung

loading

Diese Anleitung auch für:

Q60-e serieQ6054-eQ6055-e