Axis Communications Q6052-E Installationsanleitung Seite 13

3. Make sure the rubber gasket is fitted correctly on the dome cover.
4. Align the bulge on the dome cover with one of the logotypes on the dome ring.
5. Attach the dome bracket and the dome cover to the dome ring and tighten the screws
(torque 1.2 Nm).
6. To install an SD card, see Install an SD Card (optional) on page 13.
7. To attach the dome cover to the top cover, align the bulge on the dome cover with the
heater on the camera unit and tighten the screws (torque 1.5 Nm).
Install an SD Card (optional)
Installing an SD card is optional. A standard or high capacity SD card (not included) can be used to
store recordings locally in the product.
1. Loosen the dome ring screws and remove the dome cover.
2. Insert an SD card into the SD card slot.
3. To attach the dome cover to the top cover, align the bulge on the dome cover with the
heater on the camera unit and tighten the screws (torque 1.5 Nm).
Install the camera on a bracket mount
WARNING
Risk of electric shock. The product shall be grounded using a grounding wire. Make sure
both ends of the grounding wire are in contact with their respective grounding surfaces.
NO TICE NO NO TICE TICE
To comply with the IP66-rated design of the camera and maintain the IP66 protection,
the supplied RJ45 Push-pull Connector (IP66) shall be used. Alternatively, use the RJ45
IP66-rated cable with premounted connector which is available from your Axis reseller. Do
not remove the plastic network connector shield from the camera.
This product can be mounted with the cables routed through or along the wall or roof.
1. Install the selected bracket according to the instructions supplied with the bracket. If
drilling is required, make sure to use drill bits, screws and plugs that are appropriate for
the material.
2. Secure the camera using the supplied safety wire.
3. Route the network cable and a grounding wire through the holes in the mounting
bracket. Make sure the grounding wire is as short as possible to make the current path
as short as possible.
4. Loosen the grounding screw and remove the washer and cable shoe.
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
AXIS Q60-E Series
13