Axis Communications Q6052-E Installationsanleitung Seite 19

NO TICE NO NO TICE TICE
The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the network shall be intended for their specific use. Make sure that the
network devices are installed in accordance with the manufacturer's instructions. For
information about regulatory requirements, see Electromagnetic Compatibility (EMC) 2.
NO TICE TICE
NO NO TICE
To comply with the IP66-rated design of the camera and maintain the IP66 protection,
the supplied RJ45 Push-pull Connector (IP66) shall be used. Alternatively, use the RJ45
IP66-rated cable with premounted connector which is available from your Axis reseller. Do
not remove the plastic network connector shield from the camera.
SD card slot
NO TICE TICE
NO NO TICE
• Risk of damage to SD card. Do not use sharp tools, metal objects or excessive force when
inserting or removing the SD card. Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Do not remove the SD card while the product
is running. Disconnect power or unmount the SD card from the Axis product's webpages
before removal.
This product supports SD/SDHC/SDXC cards (not included).
For SD card recommendations, see www.axis.com
Operating Conditions
The Axis product is intended for outdoor use.
Product
AXIS Q6052-E
AXIS Q6054-E
AXIS Q6055-E
* Arctic Temperature Control enables camera start-up at temperatures as low as -40 °C (-40 °F)
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
Classification Temperature
IEC 60721-4-3 -50 °C to 50 °C
Class 3K3, 3M3 (-58 °F to 122 °F)*
IEC 60529 IP66 Maximum
temperature
(intermittent):
60 °C (140 °F)
AXIS Q60-E Series
Humidity
10–100% RH (condensing)
19