AEG DFH8661B Montageanleitung Seite 38

Setting the light colour temperature
The hood remembers the last setting of
the light colour temperature.
There are two ways to set the light colour
temperature:
1. Touch the symbol to change the
colour temperature from neutral, through
warm to cold.
2. Touch and hold the
smoothly between light colour
temperatures.
Release it once you reach the desired
setting.
3.2 Hob²Hood function
It is an automatic function which connects the
hob with a hood. Both the hob and the hood
have an infrared signal communicator. Speed
of the fan is defined automatically on basis of
mode setting and temperature of the hottest
cookware on the hob. You can also operate
the fan using the hob manually. The function
can be activated from panel of the hob.
If the hood drawer is closed, the
Hob²Hood will only activate the hood
light. The fan will remain off.
If the drawer is open, the function will
activate both the hood light and the fan.
For more information how to use the
function, refer to the hob user manual.
3.3 Filter notification
Filter alarm reminds to change or clean the
charcoal filter and clean the grease filter. The
symbol to move
38
symbol blinks regularly for 30 seconds if
the grease filter must be cleaned. The
symbol blinks twice per every second for 30
seconds if the charcoal filter must be
replaced.
This function activates independently
after 40 hours of operation for grease
filter and 160 hours of operation for
charcoal filter.
Refer to Cleaning the grease filter in the
Care and cleaning chapter.
Refer to Replacing the charcoal filter in
the Care and cleaning chapter.
The function counter for charcoal filter is
disabled by default. For recirculation
mode, it must be activated.
To activate or deactivate the counter for
charcoal filter:
1. Pull out the hood drawer.
2. Make sure the fan and the light are turned
off.
3. Touch symbol for 3 seconds.
The function is activated if symbol
once. The function is deactivated if symbol
blinks twice.
To reset the function counter in the
notification period:
1. Pull out the hood drawer.
2. Touch symbol for 3 seconds.
The symbol stops blinking for the correct
reset.
blinks