Werbung
Verfügbare Sprachen
Verfügbare Sprachen
®
Controls and Sockets
(D
Universal
Input/
Output Socket
For recording broadcasts (stereo or mono)
.
For playback via a stereo radio or
amplifier.
For recording via an external microphone with re-
mote control switch (GDM 308 mono)
.
When connecting to this socket, the built-in micro-
phone is automatically disconnected
.
When connecting to mono equipment it may be
necessary to use adaptor plug 294.
@
Battery Meter
For checking the condition of the batteries (in
the start position).
@
Built-in Microphone
For recording when no connection is made to
socket (D. When recording the loudspeaker output
stage is disconnected
.
©
Tape Switch
Position Cr
for Chromium dioxide tapes
Position FeCr
for Ferrochrome tapes
Position Fe
for Iron oxide tapes
®
Tone Control
?
Bass
.
.. treble'
@
Volume Control
Soft...........- loud
(Z)
Stop Key
Releases the function keys and the record key.
@
Record Key
With cassette inserted press and hold down until
start key @ has also been depressed. The key is
automatically locked in the off position if no cas-
sette is fitted or if the cassette is protected
against accidental
erasure.
©
Tape Position Indicator with Reset Button
For easy location of individual recordings.
8
@)
Rewind Key
Press to rewind tape, press stop key (Z) when the
required position is reached according to position
indicator.
®
Pause Key
Press this key to temporarily stop the tape during
record or playback.
@
Start Key
Press to start tape for record and playback.
@
Forward Wind Key
Press to forward wind
tape,
press stop key (Z)
when the required position is reached according
to position
indicator.
@
Cassette Compartment Button
Press to open lid of cassette compartment
@.
@
Cassette Compartment
Open lid by pressing cassette compartment button
@
,
start key @ must first be released. Insert cas-
sette as far as possible rear first with the full
spool to the
left.
Close cassette compartment lid.
@
Mains Socket
The internal batteries will be switched off (if
fitted), when the mains lead is connected
.
(Push
the mains cable plug completely
in).
@
Loudspeaker Output Socket
When connecting an external loudspeaker or ear-
phone to this socket the internal loudspeaker will
automatically be switched off.
@)
Battery Compartment
To open push cover in direction of
arrow.
Fit bat-
teries as indicated on the bottom of the compart-
ment.
®
Handle
Puff out for transport.
General
This recorder incorporates a built-in mains power
supply and is ready to operate as soon as it is
connected to the mains
supply.
Disconnect from
mains by removing mains plug from the rear (dis-
connect from the wall socket first)
.
The built-in microphone
@
enables you to make
recordings at any time without the need of acces-
sories. Please unfold the flap inside the
f
ront
cover
,
all controls are explained briefly and the
numbers used in the illustrations are identical with
those in the te xt. The range of accessories can
be found on page 2. The type label is on the
un-
derside of the recorder.
Voltage Supply
This recorder can operate in two ways
:
1. Independent of the mains supply by using
6 x 1.5 V cells
.
2.
From a 220-230 V (±
to'i,),
50 .
..
60 Hz AC
mains
supply.
Additional Information for sets sold
in Great Britain
The set is designed to operate from a mains
supply of 240 V AC
.
We recommend that a
13 amp 3-pin plug fitted with a 2 amp fuse
be used
.
The brown lead should be connected
to
the
live
pin
(marked
"L"
or
"red"
or
"brown") and the blue lead must be connect-
ed to the neutral pin (marked
"N"
or "black"
or "blue"). On no account should either of the
wires be connected to the earth pin (marked
"E" or
"green/
yellow")
.
If other mains plugs
are used
,
ensure that they are protected with
a 2 amp
fuse.
We recommend that the set be disconnected
from the mains when not In use for long
periods.
Werbung
