Magnat SB 180 Installation Seite 21

TROUBLESHOOTING
To keep the warranty valid, never try to repair the product yourself.
Malfunctions may occur with any electrical equipment. This must not always involve a defect of the
device. Therefore, check the following table to see if you can correct the problem yourself.
Malfunction
The Soundbar does not work.
No sound from Soundbar
speakers.
A device cannot connect with
the Soundbar via Bluetooth.
Quality of audio play from a
connected Bluetooth device is
poor.
The connected Bluetooth de-
vice connects and disconnects
constantly.
No reaction to the remote
control
Possible cause/Remedy
Disconnect the Soundbar from the power supply for a few minutes,
then reconnect.
Use the correct audio cable to connect your Soundbar to your TV or
other devices.
On your Soundbar remote control, press the Source buttons to
select the correct audio input.
Make sure that the Soundbar is not muted. Press VOL +/- to resto-
re the sound (see 'Adjust the volume').
Switch or set to other audio signal of your connected external
device (this product supports Dolby Digital and LPCM).
The device does not support the compatible profiles required for
the Soundbar.
You have not enabled the Bluetooth function of the device. See the
user manual of the device on how to enable the function.
The device is not connected correctly. Connect the device correctly.
The Soundbar is already connected with another Bluetooth device.
Disconnect the connected device, then try again.
The Bluetooth reception is poor. Move the device closer to the
Soundbar, or remove any obstacle between the device and the
Soundbar.
The Bluetooth reception is poor. Move the device closer to the
Soundbar, or remove any obstacle between the device and the
Soundbar.
For some Bluetooth devices, the Bluetooth connection can be
deactivated automatically to save power. This does not indicate any
malfunction of the Soundbar.
The battery has been exhausted, please replace by a new one.
Ensure the battery is placed correctly.
21