Magnat SB 180 Installation Seite 20

Choose your sound
Select predefined sound modes to suit your video
or music.
Press the sound setting buttons on the remote
control to select a sound mode.
• When a button is pressed, the POWER
indicator blinks once.
• MUSIC: Recreate the original recording
environment of you music, in the studio or at
a concert.
• MOVIE: Enjoy a cinematic audio experience,
specially enhanced for movies.
• VOCAL: Hear every word with optimized speech
and clear vocals.
• LINEAR: Flat and pure sound mode. Ideal for
listening to classical music.
Play audio through Bluetooth
Through Bluetooth, connect the Soundbar with
your Bluetooth device (such as an iPad, iPhone,
iPod touch, Android phone, or laptop), and then
listen to the audio files on your device through
your Soundbar speakers.
s
What you need:
• A Bluetooth device which supports version 3.0
+ EDR.
• The operational range between the Soundbar
and a Bluetooth device is approximately
10 meters (30 feet).
1. Press on the remote control to switch the
Soundbar to Bluetooth mode.
The PAIR INPUT indicator on the front panel
of main unit blinks slowly.
2. On the Bluetooth device, switch on Bluetooth,
search for and select MAGNAT SB180 (see the
user manual of the Bluetooth device on how to
enable Bluetooth).
3. When the Bluetooth connection succeeds, the
Bluetooth indicator lights up.
If no Bluetooth device is connected within
two minutes, press PAIR on remote control to
activate the pairing mode again.
4. Select and play audio files or music on your
Bluetooth device.
During play, if a call is coming, music play is
paused. Play resumes when the call ends.
5. To exit Bluetooth, select other source.
When you switch back to Bluetooth mode, the
Bluetooth connection remains active.
Note
The music streaming may be interrupted by
obstacles between the device and the Soundbar,
such as wall, metallic casing that covers the
device, or other devices nearby that operate in the
same frequency.
If you want to connect your Soundbar with another
Bluetooth device, press PAIR button to disconnect
the current connection.
Note
This product supports Dolby Digital and LPCM.
DTS is not supported.
Sampling frequency: 32KHz, 44.1KHz, 48KHz.
Auto Standby
When playing media from a connected device,
the Soundbar automatically switches to standby
after 20 minutes if no audio play is started from a
connected device.
Applying factory settings
You can reset your Soundbar to the default
settings programmed at the factory.
1. On your remote control, press the LINE INPUT
button.
2. Press MUSIC, VOL- and VOCAL on the remote
control within 3 seconds to restore the factory
default settings.
When the factory setting have been restored,
the system shuts down into standby mode and
restarts.
20