SOMFY animeo Gebrauchsanweisung Seite 10

GB
A
PICTURES
[1] animeo EnOcean Receiver 868 MHz (Ref. 1860220)
[2] EnOcean PTM 200/PTM 210 Module has 2 channels
(A and B)
B
MOUNTING
[1] Switch off voltage supply
Remove the cover of the animeo Motor Controller.
Place the animeo EnOcean Receiver 868 MHz.
Switch on voltage supply.
The LED's shine according to the diagram.
C
CONFIGURATION/STATUS INDICATION
Several animeo EnOcean Receiver 868 MHzs should not
be programmed at the same time.
A maximum of 20 PTM 200/PTM 210 channels can be
stored per animeo EnOcean Receiver 868 MHz.
The learning readiness ends automatically after 60
seconds if no input takes place.
[1] Learn-in one channel
Press PROG button on Motor Controller for approx.
2 seconds. Green LED lights up, the drives confirm
with short up/down movement. Briefly operate the
"I" or "0" button of the trained sender 3 times. Press
PROG button on Motor Controller briefly. Green LED
goes out, the motors confirm with short up/down
movement.
[2] Learn-in one channel with allocation of the motor
outputs
Press PROG button at the Motor Controller for 2 sec-
onds. Green LED lights up, the motors confirm with
short up/down movement. Briefly operate the "I"
or "0" button of the learned-in sender 3 times. The
motors confirm with short up/down movement. The
"I" button is for switching between the individual
motors, motor confirms with short up or down
movement. The "0" button is to confirm or delete
the allocation of the selected motor.
1.
movement.
2.
movement.
Press PROG button at the Motor Controller. Green LED
goes out, the motors confirm with short up/down
movement.Setting successful.
[3] Learn-in more channels
See topic [1] or [2].
[4] Deleting a channel
If the learn-in process is repeated with an already
trained channel, it will be deleted. Green LED goes
out, the motors confirm with short up or down
movement.
[5] Reset to delivery status
Press PROG button on Motor Controller and keep it
pressed. Green LED lights up after 2 seconds, all mo-
tors confirm with short up/down movement. After
another 5 seconds all motors confirm with a short
up or down movement. animeo EnOcean Receiver
868 MHz is again in the delivery state.
If the PROG button of the Motor Controller is
kept pressed for longer than 10 seconds, the Motor
Controller will also be reset!
animeo enocean Receiver 868 MHz . REF. 5109570-
or down
10/16