Troubleshooting - Klarstein 10027054 Bedienungsanleitung

Set the time and speeds before start.
a) time setting
when machine in standby mode, the LED window indicate "00:00", push "TIME" button, in default
status is "01:30"(1minute and 30 seconds) , you can push "+" or "-" to add or reduce the time,5
seconds's change when you push the "+" or "-" each time. Such as push "+" button one time,
the time is "01:35", push it again, the time is "01:40"... "-" button is opposite setting. Max time is
"02:00", Min time is "00:00".
b) speed setting
push "SPEED" button, the "SPEED" indicator light will be on. in default status is ": 250. It is Max
speed), you can push "-" to reduce the speed, 1000 RPM's change each time. Such as push "-"
button one time, the speed is "240"(push it again, the speed is "230"...,Min speed is "150".
Completed above time and speed setting, then push "START/END" button, machine start working.
Start working, then set the time and speeds.
a) when machine in standby mode, push "START/END" button, machine start working with default
data(time is 01:30, speed is 250)
b) Push "TIME"or "SPEED" button, then make the time or speed setting by "+" or "-" button.
Tips: you can change the speed or time by "+"/"-" button when blending.
"AT/PULSE" button
when machine in standby mode, push this button one by one time, usually for ICE crush function.
5. Completed blending, push "START/END" button, blender stop working.
MAINTENANCE TIPS
1. When cleaning or maintaining, unplug appliance and ensure main switch is turned to off position.
2. Clean the blender body and the cover with a sponge or cloth
3. Do not clean inside the jug by hand unless the blade is already removed.
4. Clean the rotary shaft and the motor base with a dry rag.
5. If required use a clean cloth with a mild-ph detergent to clean. Never place the motor base in
water or other liquid.

TROUBLESHOOTING

Check if the current protector button is turned off, press it and then reset. If the blender still doesn't
work. Check the following:
1. Whether the appliance is plugged in
2. If there is a power cut
3. If none of the above applies, please do not attempt to fix the blender yourself and instead, ask
specialized personnel for repair or approved supplier for replacement.
CHAL-TEC Vertriebs- + Handels GmbH; Wallstraße 16; 10179 Berlin, Germany
7