clearaudio electronic smart matrix SI LENT Bedienungsanleitung Seite 7

User manual / Bedienungsanleitung
3. Set-up and operation
3.1
smart matrix SI LENT
Place the
The surface should be waterproof.
Please make sure that the machine is positioned safely and securely.
TIP: We recommend keeping a towel near the machine to mop up any fluid spillage.
3.2
Connect the mains cable to your smart matrix SI LENT and then to your wall socket.
smart matrix SI LENT must always be used with a grounded mains wall socket.
The
I MPORTANT:
Please read before you connect your
smart matrix SI LENT
The
The correct voltage is indicated on the rear of your
Please make sure that you use the right voltage for your machine.
Pic. 1: IEC socket on the rear side
Pic. 2: Filling the cleaning fluid reservoir
Made in Germany
machine on a clean, dry and stable surface.
smart matrix SI LENT
is available in both 230V and 110V versions.
Use your
indicated on the rear of the machine!
To switch off the device completely (to avoid
unnecessary standby consumption if it w ill not be
used for a long period of time) w e recommend setting
the sw itch on the I EC socket to the position "0".
3.3 Filling the cleaning fluid reservoir
Remove the cap from the cleaning fluid reservoir and place the
filling funnel supplied into the hole (Pic. 2). Fill the fluid reservoir
with the cleaning fluid provided (max. 0.4l).
Then replace the cap.
For effective cleaning we recommend using only Clearaudio
cleaning fluid (available at www.analogshop.de).
to any pow er outlet:
smart matrix SI LENT
smart matrix SI LENT
.
only w ith the voltage
Page / Seite 7