Herunterladen Diese Seite drucken

clearaudio electronic smart matrix SI LENT Bedienungsanleitung Seite 10

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

User manual / Bedienungsanleitung
TI P: For very dirty records, w e recommend allow ing the platter to turn more than tw ice
in each direction and then repeating w ith a second or even third cleaning and vacuum
process.
Press the 'Vacuum' button (Pic. 3, No. 4) to start the vacuuming process and wait until the record
5.
surface is completely dry. Press the 'Vacuum' button again to stop the vacuuming process.
Please note:
For best cleaning results w e recommend selecting anti-clockw ise rotation of the platter
for vacuuming.
6. Now you can switch the rotation off, by lifting the cleaning/suction arm and then swinging it back
to the side. Remove the record clamp.
Flip over the record and repeat the cleaning process by following points 1-5 for the other side.
To discharge any static that is generated during the drying process, we recommend using an
antistatic brush (Art. No. AC014, available at www.analogshop.de) before playing the record on
your turntable.
6. Maintenance
Cleaning and draining the waste fluid tank
Please empty the waste fluid tank after 30 – 40 cleaning procedures.
The waste fluid tank has a capacity of approx. 0.5 litres. We recommend regular emptying of the
tank, to avoid any damage.
Please note that with intensive use, waste fluid can evaporate nearly completely leaving a residue
within the waste tank which may clump over time and possibly clog the discharge opening.
For prevention we recommend occasional cleaning.
Before you start cleaning, you should first empty the waste fluid tank.
Please make sure that you have switched off the vacuum motor while emptying the
waste fluid tank otherwise damage to the machine could occur.
Pic. 6: Emptying the waste fluid tank
Page / Seite 10
To empty the tank, first remove the stopper from the fluid
release tube (on the rear panel of the smart matrix SI LENT ).
Place the tube in an appropriate vessel (one deep enough to
capture the fluid as it is flows out). Be sure to securely replace
the stopper in the fluid release tube.
Warning:
Do not use recycled cleaning fluid. This could damage
the machine or your records.
© clearaudio
electronic GmbH, 2022-01

Werbung

loading