Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CUCINOTTA – CUCINOTTA Forno
2.
TECHNICAL DESCRIPTION
The Wood cooker s of La Nordica are suitable to cook on the grill and to heat living spaces. As fuel, wood
logs. The cooker is made of sheets in galvanized and painted steel, of cast iron (doors, front of the cooker
and cooking plate) of majolica tiles. The hearth is totally sheathed with cast-iron single sheets and
refractory material (ironker) and it is endowed with pre-calibrate tertiary air for a better combustion.
Inside there is a height-adjustable thick flat grate, which can be easily extracted.
The one-piece ceramic glass of the door (resistant up to 700 ° C) allows a wonderful view on the burnin g
flames. Furthermore, it is thus avoided the output of sparks and smoke.
Below the hearth door, there is an extractable wood drawer with its relevant closing door.
The heating of the environment is made by irradiation: through the panoramic glass and the external hot
surfaces of the cooker, the heat is radiated into the environment.
The cooker is equipped with controls of primary and secondary air by which it is adjusted the combustion
air.
2.1.
PRIMARY air control (lower lever)
Below the hearth door, on the front right side, there is
the primary air register, in the style of lever (Picture 1
pos. A)
With this air control, it is adjusted the passage of
primary air into the low part of the cooker, and through
the ash drawer and the grate, flows in the fuel direction.
The primary air is necessary for the combustion
process during lighting. The ash drawer must be
regularly emptied, so that the ash does not obstruct the
entry of the air). Through the primary air the fire is also
kept alive.
In order to open the air flow, the bar must be completely
pulled out (when the bar is completely pushed to the
back, the control is closed).
During wood combustion, the register of primary air
must be opened only for a while, because otherwise the
wood burns too fast and the cooker may overheat. (see
paragraph 10).
2.2.
SECONDARY air control (upper lever)
The secondary air control is found on the upper front
side (Picture 1 - A). This control must be open (pushed
to right) particularly for the wood combustion (see paragraph
10)
A part of the secondary air, passing between the inside glass and the hearth, heats itself starting the double
combustion, the other part flows between the two glasses and keeps at the same time them clean.
3.
RULES FOR INSTALLATION
The cooker, assembled and ready for the installation, must be connected with a junction to the existing flue
of the house. The junction must be possibly short, straight, horizontal or positioned a little uphill. The
connections must be tight.
It is obligatory to respect the National and European rules, local regulations concerning building
matter and also fireproofs rules. Please apply to your chimney sweeper for all information.
You should verify the sufficient air entrance for the combustion in the installation place, with particular
attention to windows and doors with tight closing (seal ropes).
It is not allowed the connection of various appliances to the same chimney. The diameter of the opening for
the connection must correspond at least to the diameter of the smokes pipe. The opening should be
equipped with a wall connection for the reception of the exhaust pipe and a rose window.
The small hole for the smoke connection pipe not in use must be covered with the related cap.
7093101 – Rev.05 – EN
B
A
Picture 1
17
Werbung
Inhaltsverzeichnis
