Removing The Integral Filter; Emptying The Dishwasher; Appliances With No Drain Pump; Appliances With Drain Cycle (*Optional) - MAYWAY TOP TECH 3623 Bedienungsanleitung

UK

Move the washing and rinsing arms at right angles to the edge of the door

Lift each semi-filter by the relative handle ( Fig.7 ).

Switch the dishwasher off.

Remove the integral filter ( Fig.7A ).

Pull up and remove the overflow pipe ( Fig.7 ).

Wait for the tub to empty completely.

If necessary, extract the tub filter and clean.

With the machine on, press the PROGRAMME SELECTION button (3) to select the programme
ProClean or ProDrain.

Press the START button (4), to start the drain and self-clean programme.

At the end of the drain cycle, the dishwasher will switch off; only the STANDBY LED (5) will remain
illuminated to indicate that the mains power is on.
In machines with an incorporated water softener the "REGENERATION SYSTEM ON" symbol
indicates that the machine is running a resin regeneration cycle and that the current wash
programme could be longer.
N.B. Do not switch off the machine if a regeneration cycle is underway
In machines fitted with water softener, when the warning 'NO SALT' appears you should add salt to the
relative container; proceed as follows:

Remove the basket from the machine.
Remove the integral filter ( Fig. 7 ).

Unscrew the cap on the salt container ( Fig. 8 ).


Pour approx. 700g of regeneration salt (1or 2mm grain size kitchen salt with no additives) into
the container using the funnel supplied.

Close the container firmly.

After a few minutes the 'NO SALT' warning will disappear.
On machines equipped with an external water softener, after a certain number of cycles, the word
'SERVICE' will appear on the display; this means that it is necessary to regenerate the resin of the
external water softener. The service alert will remain even when the machine is off. To cancel it, press
and hold all 4 buttons for at least 5 seconds, with the machine off and the door open.

At the end of the day always drain the machine as described in the section Machine draining.

Disconnect the power supply by means of the main switch and close the external water cock.

Perform routine maintenance and clean the machine as described in the section Maintenance.

If possible, leave the door ajar to prevent bad odours building up inside the machine.
Page 10 of 14
INSTRUCTION MANUAL FOR DISHWASHERS

4.9 Removing the integral filter

4.10 Emptying the dishwasher

4.10.1 Appliances with no drain pump

4.10.2 Appliances with drain cycle (*optional)

4.11 Resin regeneration (*optional)

4.12 Machine with external water softener

4.13 End of shift