Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ASSEMBLY
1.
The SAfire Gas roaster is purchased fully assembled and does not require any assembly other
than connecting the Gas hose and regulator to the hose receptacle on the SAfire and the
tank
2.
Always inspect the regulator and hose for any damage, excessive abrasions or cuts If there is
any damage the hose must be replaced prior to use
3.
Inspect the Bottle/Tank/Cylinder for leaks using soapy water with a paint brush if growing
bubbles appear do not use the tank and call your LP Gas supplier
4.
Only use the regulator and hose relevant to your country see list below
5.
Be sure the LP cylinder is in the "OFF" position
6.
Be sure the burner control is in the "OFF" position
7.
Remove the safety cap from the Cylinder Valve, place the regulator into the receptacle of the
tank valve and turn the nut/Wheel anti clockwise until hand tight do not use a spanner or
wrench to tighten
Figure 1
Gas booklet resized.indd 3
ENGLISH
2016/04/19 6:52 PM
Werbung
