Werbung
Verfügbare Sprachen
Verfügbare Sprachen
REMEMBER
Our valves must be installed by professional installers in
•
accordance with current regulations and recommendations in your
country, and the specifications of the fluid engineer.
•
Sizing the pipes correctly will avoid problems of flow rate, pressure
loss and water hammer (see calculation table in our brochure and
online at www.delabie.com).
Protect the installation with filters, water hammer absorbers
•
and pressure reducers to reduce the frequency of maintenance
(recommended pressure from 1 to 5 bar (100 to 500 kPa) maximum).
Install stopcocks close to the valve to facilitate maintenance.
•
•
The pipework, filters, non-return valves, stopcocks, bib taps, cartridge
and all sanitary fittings should be checked at least once a year, and
more frequently if necessary.
MAINTENANCE & CLEANING
Cleaning chrome, aluminium and stainless steel: do not use
•
abrasive, chlorine or any other acid-based cleaning products. Clean
with mild soapy water using a cloth or a sponge.
Frost protection: drain the pipes and operate the mixer/tap/valve
•
several times to drain any remaining water. In the event of prolonged
exposure to frost, we recommend taking the mechanisms apart and
storing them indoors.
For the UK market only: Tel. 01491 821 821 -
The installation guide is available on: www.delabie.co.uk
For all other markets: Tel. +33 (0)3 22 60 22 74 -
The installation guide is available on: www.delabie.com
After Sales Care Support:
email: technical@delabie.co.uk
email: sav@delabie.fr
18
Werbung
