Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. WARNING! If the supply cord of this appliance is damaged, it must be replaced only
by a qualified service technician.
Cleaning the Chipper/Shredder
1. Turn the Hopper Locking Knob counterclockwise and remove the Hopper.
2. Clean the cutting Blades and discharge area and remove wood sticks or objects that may
clog the Blades.
3. Check the Blades for damage and replace if needed.
4. Return the Hopper to its upright position and tighten in place with the Locking Knob after
cleaning the interior.
5. Use a warm damp cloth and a soft brush to
clean the exterior of the Chipper/Shredder.
Do not spray water or use detergents on
the Chipper/Shredder.
6. Check that the ventilation slots are clean.
Replacing the Blades
The reversible Blades are attached to the
Cutter Head with two screws.
1. Access the Blades by removing the Hopper.
2. Align the slots on the Cutter Head and main body and insert a screwdriver or other metal rod
(sold separately) to prevent the unit from rotating while changing the Blades.
3. Unthread the two screws holding a Blade and carefully remove the Blade.
4. Either reverse the Blade with the sharp edge in the cutting position, have the blade profes-
sionaly sharpened/honed, or insert a new Blade.
5. Secure in place with the screws. Repeat with the other Blade at the same time.
Blades
Screws
Figure E
E7
Werbung
