Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Keep a safe distance from the Hopper opening. Longer material can lash out when being
pulled in by the blades.
Keep clear of intake and discharge chute. Use included push paddle. Unplug unit and
allow it to stop before unclogging.
Keep the ventilation slots clear while working to avoid overheating.
9. Do not shred soft, damp material such as kitchen waste as it may clog the Chipper/
Shredder. Let damp garden waste dry for a few days before shredding.
10. Remove soil and rocks from roots before inserting them into the Chipper/Shredder.
11. Use the push paddle to feed leaves and other small material into the Hopper.
12. Feed material into the Chipper/Shredder at the rate that the machine pulls the material. Do
not force material into the machine.
13. Set aside a few dry branches, then feed them into the machine when finished, to help clean
the unit.
14. Wait for all material to pass through the Chipper/ Shredder before turning the unit off.
15. To prevent accidents, turn the power off, and disconnect the power supply after use. Clean,
then store the appliance indoors out of children's reach.
Overload Protection
This Chipper/Shredder is equipped with an overload protection system. If the unit clogs while
running, the overload protection system will shut the power off. Wait at least one minute before
restarting. Press the Reset Button then turn the Power Switch on.
Maintenance and Servicing
Procedures not specifically explained in this manual must be performed only by a qualified
technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION OR ELECTRIC
SHOCK:
Turn the Power Switch of the appliance to its "OFF" position and unplug the appliance
from its electrical outlet before performing any inspection, maintenance, or cleaning
procedures.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the
problem corrected before further use.
Cleaning, Maintenance
1. BEFORE EACH USE, inspect the general condition of the tool. Check for:
• Loose hardware
• Misalignment or binding of moving parts
• Cracked or broken parts
• Damaged cord/electrical wiring
• Any other condition that may affect its safe operation
2. AFTER USE, clean external surfaces of the appliance with clean, moist cloth.
3. Replace or sharpen the Blades as needed. (See below.)
4. If the motor turns but the appliance does not function, the belt may be broken. Have the belt
replaced by a qualified technician.
E6
Werbung
