Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Set Up Instructions
Read the ENTIRE IMPORTANT SAFETY INSTRUCTIONS section at the beginning of this
manual including all text under subheadings therein before set up or use of this
product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the appliance to its "OFF" position and unplug the appliance
from its electrical outlet before assembling or making any adjustments.
Note: For additional information regarding the parts listed in the following pages, refer to the
Assembly Diagram near the end of this manual.
ASSEMBLY
1. Slide the Axle (65) through the holes on the Lower Frame (64).
2. Slide a Washer (66), a Bushing (67), a Wheel (68) and another Washer (66) onto one end of
the Axle.
3. Secure in place with a Pin (63).
4. Repeat steps 2 and 3 on the other end of the Axle.
5. Press the Wheel Covers (62) onto the Wheels, over the Pins, using a rubber mallet (sold
separately) to lightly tap them in place if needed.
6. Turn the Chipper/Shredder upside down and slide the Lower Frame ends into the
slots on the Base.
7. Align the holes and secure in place with two Washers and Screws.
Bushing
Wheel
Lower Frame
Axle
E4
Wheel Cover
Washer
Pin
Figure A
Base
Slots
Figure B
The Handle of
the feed hopper (1)
Werbung
