Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Functions
Control Panel
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Operation
1. Before operating the Chipper/Shredder, put on ANSI-approved safety goggles and other
safety gear. Safety goggles and other safety gear are sold separately.
2. If an extension cord is used, ensure that it is an outdoor type extension cord and that it is the
correct design to accept this appliance's plug.
TO PREVENT ELECTRIC SHOCK AND SERIOUS PERSONAL INJURY:
The extension cord must remain secured to the appliance's plug.
Secure the extension cord by either using the knot method explained in the safety
warning section, or by using a device designed specifically for retaining the extension
cord (sold separately).
3. Check that the Power Switch is OFF.
4. Check that the feed inlet is empty.
5. Check that the Hopper is securely closed and that the Hopper Locking Knob is turned fully
lockwise.
Note: The Chipper/Shredder will not run if the Hopper is open, not fitted well, or the Hopper
Locking Knob is loose.
6. Plug the Power Cord into a 230VAC/50Hz outlet.
7. Turn on the Power Switch.
8. Hold branches and feed them into the hopper. Release the branches when they begin to pull
into the hopper.
Hopper
Hopper
Locking Knob
Power Switch
Base
Reset
Button
Control Panel
Lower Frame
Figure C
E5
Werbung
